How To Jump Start Hyundai Elantra

Hyundai Elantra: What To Do in an Emergency / Spring Starting

Jump starting tin be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt virtually how to properly leap commencement your vehicle, nosotros strongly recommend that you have a service technician or towing service do it for you.

Alert

To forestall SERIOUS INJURY or DEATH to you or bystanders, ever follow these precautions when working nigh or handling the battery:

Always read and follow instructions carefully when treatment a battery.

Clothing eye protection designed to protect the eyes from acid splashes.

Continue all flames, sparks, or smoking materials abroad from the battery.

Hydrogen is always nowadays in battery cells, is highly combustible, and may explode if ignited.

Continue batteries out of reach of children.

Batteries contain sulfuric acid which is highly corrosive. Do not allow acid to contact your eyes, pare or habiliment.

If acid gets into your eyes, flush your eyes with clean water for at least xv minutes and become immediate medical attending. If acid gets on your skin, thoroughly wash the area. If you feel pain or a called-for awareness, go medical attention immediately.

• When lifting a plastic-cased battery, excessive pressure on the case may cause battery acid to leak. Lift with a bombardment carrier or with your hands on contrary corners.
• Exercise not endeavor to jump showtime your vehicle if your battery is frozen.
• NEVER attempt to recharge the battery when the vehicle's bombardment cables are continued to the battery.
• The electric ignition system works with loftier voltage. NEVER touch these components with the engine running or when the ignition switch is in the ON position.

Data

An inappropriately tending battery can be harmful to the surround and human health. Dispose of the battery according to your local law(s) or regulations.

NOTICE

To forestall harm to your vehicle:

• Simply use a 12-volt ability supply (bombardment or jumper system) to leap start your vehicle.
• Exercise not attempt to jump outset your vehicle by push-starting.

Jump starting procedure

1. Position the vehicles close enough that the jumper cables will reach, but do non let the vehicles to touch.

ii. Avoid fans or any moving parts in the engine compartment at all times, even when the vehicles are turned off.

3. Turn off all electrical devices such every bit radios, lights, air conditioning, etc. Put the vehicles in P (Park) and set the parking brakes. Plow both vehicles OFF.

iv. Connect the jumper cables in the exact sequence shown in the illustration. Beginning connect one jumper cable to the ruby-red, positive (+) jumper last of your vehicle (i).

5. Connect the other cease of the jumper cable to the red, positive (+) battery/jumper terminal of the profitable vehicle (2).

6. Connect the second jumper cable to the black, negative (-) battery/ chassis ground of the assisting vehicle (3).

vii. Connect the other end of the second jumper cable to the blackness, negative (-) chassis ground of your vehicle (4).

Do not allow the jumper cables to contact annihilation except the right bombardment or jumper terminals or the right basis. Practise not lean over the battery when making connections.

viii. Start the engine of the assisting vehicle and allow information technology run at approximately 2,000 rpm for a few minutes. Then commencement your vehicle.

If your vehicle volition not showtime afterward a few attempts, it probably requires servicing. In this event please seek qualified assist. If the cause of your battery discharging is not apparent, accept your vehicle checked past an authorized HYUNDAI dealer.

Disconnect the jumper cables in the exact opposite order you continued them:

one. Disconnect the jumper cable from the black, negative (-) chassis basis of your vehicle (4).

2. Disconnect the other finish of the jumper cablevision from the black, negative (-) battery/chassis ground of the profitable vehicle (three).

3. Disconnect the 2nd jumper cable from the blood-red, positive (+) battery/jumper terminal of the assisting vehicle (2).

4. Disconnect the other end of the jumper cable from the red, positive (+) jumper terminal of your vehicle (1).

If the Engine Will not Offset

If the Engine Doesn't Plow Over or Turns Over Slowly Be sure the shift lever is in N (Neutral) or P (Park). The engine starts only when the shift lever is in N (Neutral) or P (Park). Chec ...

If the Engine Overheats

If your temperature estimate indicates overheating, y'all experience a loss of power, or hear loud pinging or knocking, the engine may be overheating. If this happens, you should: 1. Pull off the route ...

Source: https://www.helantraad.com/jump_starting-4169.html

Share this post